Home > News > Replacing HPS and Metal Halide with LEDs

News

Replacing HPS and Metal Halide with LEDs
2013-04-27 14:10:41
 

We offers LED Retrofit Kits that allows you to replace the Metal Halide, High Pressure Sodium or Mercury Vapor bulbs and ballasts in your existing fixtures. Retrofitting is no more difficult than a bulb and ballast replacement. Our kits are designed to screw into the existing socket (E26 or E39) and is designed to retrofit High Bays, Low Bays Garage Fixtures, Wall Packs, Flood Lights, Street Lights, Wall Washers, High Masts and more. The basic criteria is that your existing fixture has to be large enough to accommodate the LED retrofit kits.

What are the steps to retrofit an existing HID Fixture with our retrofit kits?
Turn off the power to the existing fixture
Remove the bulb and ballast from the fixture.
Remove the reflector (assuming that the reflector is not part of the fixtures waterproof seal).
Install the LED driver in the location of the HID ballast. Wire the driver to the input wire.
Install the LED Retrofit head. Wire the driver to the head (Note: the socket is used to hold the LED Retrofit head. The driver is wired directly to the LED Retrofit head)
Aim the head in the fixture.
Turn the power back on.

Top 3 Reasons you should convert with LED Retrofits
Reduced energy costs: our Industrial Strength LED Lights use approximately 25% of the electricity HID lights use.
Reduced maintenance cost: our long life LED Retrofits are rated for 100,000 hours. That means no bulbs or ballasts to replace.
Reduced project costs: use your existing fixtures saves you money!

Applications
Sports Stadiums
Parking Lots / Parking Garages
Hospitals
Schools
Roadways / Interstate
Prisons
Terminals
Warehouses
Factories
Airports


Previous   [Return Home] [Print] [Go Back]   Next

Brand Zone

  •                

Contact Us

  • Contact Person:

    deng
  • Tel:

    +86-0755-36978628
  • Fax:

    +86-0755-36978628
  • E-mail:

    deng@ledreit.com